To achieve optimum work results with the FEIN cordless screwdriver ASCM 18-4 QM(P) using the HOLESAW ADAPTER and TCT HOLESAWS, it is important to observe general guidelines depending on the application. The following maximum outputs can be achieved:.

CORDLESS DRILL/DRIVER | METAL CORE DRILLING

Application tips for hole sawing up to Ø 80 mm in sheet metal and up to Ø 68 mm in stainless steel

To achieve optimum work results with the FEIN cordless screwdriver ASCM 18-4 QM(P) using the HOLESAW ADAPTER and TCT HOLESAWS, it is important to observe general guidelines depending on the application. The following maximum outputs can be achieved:

  • Max. Drill Ø in sheet metal, material thickness 4 mm with TCT hole saw QIP: Ø 80 mm
  • Max. Drill Ø in steel, stainless steel pipe, material thickness 4 mm with TCT hole saw for pipes QIP: Ø 68 mm

HAND-GUIDED HOLE SAWING WITH HM HOLE SAWS / HM HOLE SAW FOR PIPES QUICKIN PLUS

Step 1: Centre Drilling

3rd gear, 2,000 rpm, accessory: CENTRING DRILL

  • Centre drilling in one operation.
  • Sufficient cooling / lubrication.
  • Gear change depending on diameter.
  • After material breakthrough of the carbide hole saw, return from the finished drill hole in turning mode.

Step 2: Hole Sawing

Accessories: Carbide hole saw Ø 14 – 29 mm, 2nd gear, 850 rpm

  • Maximum recommended material thickness 4 mm.
  • If necessary, 6 mm is also possible.

Accessories: HM hole saw Ø 30 – 59 mm, 1st gear, 430 rpm

  • Throttle switch pressed to maximum.
  • Maximum recommended material thickness 4 mm.
  • If required, 6 mm is also possible.

Accessories: HM hole saw Ø 60 – 80 mm, 1st gear, 430 rpm

  • Throttle switch pressed halfway for optimum drilling progress.
  • Maximum recommended material thickness 4 mm.
  • If required, 6 mm is also possible.

HAND-GUIDED HOLE SAWING IN STAINLESS STEEL SHEET WITH HM HOLE SAWS / HM HOLE SAW FOR PIPES QUICKIN PLUS

Step 1: Centre Drilling

3rd gear, 2,000 rpm, accessory: CENTRING DRILL

  • Centre drilling in one operation.
  • Sufficient cooling / lubrication.
  • Gear change depending on diameter.
  • After material breakthrough of the carbide hole saw, return from the finished drill hole in turning mode.

Step 2: Hole Sawing

Accessories: HM hole saw Ø 14 – 44 mm, 1st gear, 430 rpm

  • Throttle switch pressed to maximum.
  • Maximum recommended material thickness 4 mm.
  • If necessary, 6 mm is also possible.

Accessories: HM hole saw Ø 45 – 80 mm, 1st gear, 430 rpm

  • Throttle switch pressed halfway for optimum drilling progress.
  • Maximum recommended material thickness 4 mm.
  • If required, 6 mm is also possible.
Relevant Products